FRITZ!Box 7330 – Service - Knowledge Base

FRITZ!Box 7330 – Service

Opening the FRITZ!Box user interface in "IP Client" or "wireless repeater" mode when the IP address is unknown

If you use the FRITZ!Box as an "IP client" or "wireless repeater", you can no longer enter to access the user interface. Instead, you can only use the IP address manually assigned to the FRITZ!Box.

If you have forgotten the IP address that was manually assigned to your FRITZ!Box, you can still open the FRITZ!Box user interface.

Important:Some of the settings described here are only displayed if the advanced view is enabled in the user interface. The configuration procedure and notes on functions given in this guide refer to the latest FRITZ!OS

1 Opening the FRITZ!Box user interface

If you are using an additional FRITZ!Box as a wireless access point or router and FRITZ!OS 5.20 or later is installed on it, then you can access the user interface as follows:

  1. Open the user interface of the FRITZ!Box that you are using as the wireless access point or router.
  2. Click "Home Network" and then "Network".
  3. Click on the "Devices and Users" tab.
  4. From the list, select the FRITZ!Box that you are using as the wireless repeater or IP client and whose user interface you would like to open.
  5. Click on the name of this FRITZ!Box.
    • The user interface of this FRITZ!Box opens.

2 Using an "emergency IP" to open the user interface


  1. Remove all network cables from the LAN ports on the FRITZ!Box.
  2. Push the "WLAN" button on the FRITZ!Box to disable the wireless network.
    • The WLAN LED begins flashing. The wireless network is switched off as soon as the "WLAN" LED goes off.
  3. Use a network cable to connect a computer to a LAN port on the FRITZ!Box.

Opening the FRITZ!Box user interface